STEP BY STEP APPLICATION PROCESS

 STEP 1 - Wash glass down with clean cold water

STEP 2 - Apply Pre-Clean with a lambswool T-Bar or white nylon pad using 4-1 mixture

Agitate Pre-Clean on glass cleaning off surface contamination

STEP 3 - Wash off with clean water

STEP 4 - Spread WSR onto a small area (400mm2) of the glass with a white non-scouring pad and agitate the glass in a “circular like” manner. If water staining is proving too difficult to remove, then agitate with a red pad.

NB: Never use a white or red pad to remove water staining from exterior glass. If using a power drill on glass test in an area to ensure does not make markings.

STEP 5 - Once water staining has been removed hose down the glass with cold water and agitate with white pad to remove excess WSR.

STEP 6 - Squeegee dry and apply Renovator to cool glass

STEP 7 - Wash off Renovator thoroughly with clean water and do a water flattening test

If glass is still showing contamination, repeat steps WSR

STEP 8 - Squeegee dry and remove excess water from glass and framework with a clean dry cloth while continuing to ensure no evidence of water staining remains on the glass

STEP 9 - Apply neutraliser to dry glass using a clean dry cloth

STEP 10 - Immediately after neutralising, apply ClearShield using lint free cloth.

STEP 11 - Allow ClearShield to cure for a minimum of 15 minutes then repeat steps 9 & 10. After a further 15 minutes and to ensure a bond has occurred, wipe a small area at the bottom of glass vigorously with cloth, then do water repelling test

STEP 12 - Remove excess polymer using Clean-All Concentrate mixed with water.  Five capfuls to 1 ltr water for best results

STEP 13 - Do water repelling test to confirm the ClearShield has cross linked with the glass correctly. If need to reapply neutraliser and ClearShield if not beading off correctly.